Beta 450 Instrukcja Użytkownika Pobierz pdf (Strona 13)

Assembly Procedure 1450 Tower - 3T

Stabilisers

When specied, the correct stabilisers or outriggers must always be used.

See Quantity Schedule.

When using standard stabilisers, t them now.

To attach the stabiliser, t the upper screw

clamp to frame below casting, then t the lower

screw clamp as low as possible to the frame

upright.

Stabilisers should be attached so that the

footprint of the tower, including stabilisers, is

a square of the dimensions shown on page 5.

Ensure that the stabilisers are in rm contact with

the ground.

Notes

It may be advantageous to ensure that stabilisers are tted from frame side

as shown.

It may only be possible to t extended stabilisers after upper frame has been

placed.

If repositioning stabilisers when in position then screw clamps MUST be

loosened prior to movement then re– xed.

Place a trapdoor platform at 2m level

(4 rungs from ground) and set to the

ladder side of the tower.

Note The trapdoor platform hinge to

be set to outside of tower (temporary

only to assist in assembling tower).

10.

Operative should then climb through

the trap and rest against the platform

(just below base of back) with feet rmly

placed on ladder rungs (as shown).

11.

Fit horizontal braces to both sides of

platform at 1st and 2nd rungs above

platform level to form guardrail

protection to single platform only.

Note It is safe to use the platform when

horizontal braces have been locked

and secured in place.

Add two more 4 rung frames on top of

the existing frames.

12.

13.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

Komentarze do niniejszej Instrukcji

Brak uwag

Beta 450 Instrukcja Użytkownika Strona 13

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Motocykle Beta 450